Pocket Wizard CM-E3-ACC | Conns Cameras | Ireland

Pocket Wizard CM-E3-ACC


Pocket Wizard CM-E3-ACC View Large Image

Pre-Trigger Remote Cable

For connecting a PlusX, Plus III, FlexTT5 or MultiMAX with ACC port to a Canon E3 remote terminal or sub miniphone (3/32" or 2.5 mm).

Out of Stock
See Alternative
Title Quantity Price Availability
Pocket Wizard CM-E3-ACC €29.99 Out of Stock
Add To Basket Add to Wishlist

Cable length: 3' (91.5 cm)

From 1/8" (3.5 mm) Stereo Miniphone

To Canon E3 Remote Shutter Release Terminal or Sub miniphone

PocketWizard Compatibility

  • PlusX
  • Plus III
  • FlexTT5
  • MultiMAX with ACC port
  • Use the CM-E3-P or CM-E3 for the Plus II, older MultiMAX, or other PocketWizard radios.

Description: This is a special remote motor drive cable called a Pre-Trigger Cable.  A Pre-Trigger cable controls both the half-press and full-press function of your remote camera's shutter release.  When a camera is 'pre-triggered', it is like holding your camera's shutter release button in the half-pressed or metering/focusing position.

This -ACC cable allows a compatible PocketWizard radio to independently control both half-press and full-press functions.

A standard cable works with most PocketWizard radios but has no half-press control, and is for basic remote triggering only.

A -P cable works with most PocketWizard radios.  This pre-trigger cable has a switch that allows you to toggle half-press on or off at the camera position, but not remotely.

Compatible with the following radios:

PlusX: Use this cable with the PlusX to trigger the camera.  

Plus III: Use this cable with the Plus III's exclusive 2-stage trigger to wake-up or focus your remote camera just like using the camera's shutter release button.  

FlexTT5: This cable is required for relay mode with E-TTL, or other remote triggering with the FlexTT5.  Learn more here.  You can use a -P cable or standard cable with a FlexTT5, but your remote camera will not be able to relay an E-TTL signal to Speedlites.  The FlexTT5 does not support the 2-stage trigger function.

MultiMAX with -ACC port: Enable a remote zone with your hand-held MultiMAX, and your remote MultiMAX will wake up its remote camera with this cable.  As long as the zone is turned on, the remote camera will stay awake and respond more quickly and consistently, but also consume the camera's batteries much more quickly.  When the remote zone is disabled, the camera will enter its normal sleep modes.  The MultiMAX does not support the 2-stage trigger function.

Please see our PocketWizard Wiki for more details.

Compatible with cameras using Canon's E3 remote terminal or sub-miniphone connector

Clear All

Your Recently Viewed Products

Oops! Something went wrong there and we were unable to load the page you requested.

Sign Up